Installation

AUDIO / VISUAL: RADIO ANTENNA CORD: INSTALLATION

INSTALLATION

1. INSTALL ANTENNA CORD SUB-ASSEMBLY
HINT: The double-sided tape and tape are not available as supply parts. If these tapes still have enough adhesion to secure the roof headlining and antenna cord, reuse the tapes. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedures below.

(a) Apply new double-sided tape.




(1) Remove the double-sided tape from the roof headlining assembly.
(2) Peel off the appropriate amount of new double-sided tape. Be careful not to touch the adhesive surface.
(3) Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.
(4) Peel off the backing sheet from the double-sided tape.
(b) Install the antenna cord to the roof headlining assembly from the front of the vehicle.








HINT: Align the taped part of the antenna cable with the protrusion of the roof headlining, and apply tape to secure the cable to the headlining.

(c) Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
HINT:
- If the tape is no longer sticky, use other tape, such as packing tape, that has enough adhesion to secure the antenna cord to the roof headlining assembly.
- For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them.
- For the right rear corner of the roof headlining assembly, align the marking tape on the antenna cord with the rear edge of the roof headlining, and secure the antenna cord to the roof headlining assembly with tape.

2. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Installation
3. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Installation
4. INSTALL SUNSHADE TRIM HOLDER (w/ Rear Sunshade) Installation
5. INSTALL SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof) Installation
6. INSTALL SPOT LIGHT ASSEMBLY (w/ Sliding Roof) Installation
7. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof) Installation
8. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY Installation
9. INSTALL REAR ASSIST GRIP SUB-ASSEMBLY Installation
10. INSTALL VISOR HOLDER Installation
11. INSTALL VISOR ASSEMBLY LH Installation
12. INSTALL VISOR ASSEMBLY RH Installation
13. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation
14. INSTALL FRONT PILLAR GARNISH LH Installation
15. INSTALL FRONT PILLAR GARNISH RH Installation
16. INSTALL ROOF SIDE INNER GARNISH LH Installation
17. INSTALL ROOF SIDE INNER GARNISH RH Installation
18. INSTALL UPPER CENTER PILLAR GARNISH LH Installation
19. INSTALL LOWER CENTER PILLAR GARNISH LH Installation
20. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
21. INSTALL LAP BELT OUTER ANCHOR COVER Installation
22. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
23. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
24. INSTALL FRONT DOOR SCUFF PLATE LH Installation
25. INSTALL UPPER CENTER PILLAR GARNISH RH Installation
26. INSTALL LOWER CENTER PILLAR GARNISH RH Installation
27. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Installation
28. INSTALL LAP BELT OUTER ANCHOR COVER Installation
29. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
30. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
31. INSTALL FRONT DOOR SCUFF PLATE RH Installation
32. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH Reassembly
33. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH Reassembly
34. INSTALL DOOR ASSIST GRIP COVER LH Reassembly
35. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH Reassembly
36. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH (for Reclining Seat Type) Reassembly
37. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (for Reclining Seat Type)
38. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
39. INSTALL REAR DOOR SCUFF PLATE LH Installation
40. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
41. INSTALL REAR DOOR SCUFF PLATE RH Installation
42. INSTALL CENTER SEAT BACK ASSEMBLY (for Reclining Seat Type) Installation
43. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Reclining Seat Type) Installation
44. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Reclining Seat Type) Installation
45. INSTALL REAR SEAT BACK COVER (for Reclining Seat Type)
46. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation
47. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH (for Fold Down Seat Type)
48. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation
49. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Fold Down Seat Type) Installation
50. INSTALL REAR SEAT BACK ASSEMBLY (for Fixed Seat Type) Installation
51. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
52. INSTALL REAR SEAT HEADREST ASSEMBLY
53. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
54. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) Installation
55. INSTALL INNER SEAT TRACK BRACKET COVER LH (for Power Seat) Installation
56. INSTALL SEAT TRACK COVER LH (for Power Seat) Installation
57. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Power Seat)
58. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) Installation
59. INSTALL INNER SEAT TRACK BRACKET COVER LH (for Manual Seat) Installation
60. INSTALL SEAT TRACK COVER LH (for Manual Seat) Installation
61. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Manual Seat)
62. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

63. INSTALL INNER SEAT TRACK BRACKET COVER RH (for Power Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

64. INSTALL SEAT TRACK COVER RH (for Power Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

65. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Power Seat)
66. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

67. INSTALL INNER SEAT TRACK BRACKET COVER RH (for Manual Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

68. INSTALL SEAT TRACK COVER RH (for Manual Seat)
HINT: Use the same procedures for the RH side and the LH side Installation

69. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Manual Seat)
70. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
(a) Engage the 6 clamps and clip and install the No. 2 antenna cord sub-assembly.





71. INSTALL NO. 2 HEATER TO REGISTER DUCT (for TMC Made) Reassembly
72. INSTALL NO. 2 HEATER TO REGISTER DUCT (for TMMK Made) Reassembly
73. INSTALL NO. 3 HEATER TO REGISTER DUCT (for TMC Made) Reassembly
74. INSTALL NO. 3 HEATER TO REGISTER DUCT (for TMMK Made) Reassembly
75. INSTALL NO. 1 HEATER TO REGISTER DUCT (for TMC Made) Reassembly
76. INSTALL NO. 1 HEATER TO REGISTER DUCT (for TMMK Made) Reassembly
77. INSTALL DEFROSTER NOZZLE ASSEMBLY (for TMC Made) Reassembly
78. INSTALL DEFROSTER NOZZLE ASSEMBLY (for TMMK Made) Reassembly
79. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMC Made) Reassembly
80. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMMK Made) Reassembly
81. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMC Made) Reassembly
82. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMMK Made) Reassembly
83. INSTALL NO. 3 INSTRUMENT PANEL STAY Installation
84. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made) Installation
85. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made) Installation
86. INSTALL NO. 1 DEFROSTER NOZZLE GARNISH Installation
87. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side) Installation
88. INSTALL INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY Installation
89. INSTALL INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY Installation
90. INSTALL FRONT PILLAR GARNISH LH Installation
91. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)
HINT: Use the same procedures for the RH side and the LH side Installation.

92. INSTALL INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY Installation
93. INSTALL INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY Installation
94. INSTALL FRONT PILLAR GARNISH RH Installation
95. INSTALL NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made) Installation
96. INSTALL NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made) Installation
97. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made) Installation
98. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made) Installation
99. INSTALL CONSOLE BOX ASSEMBLY (for TMC Made) Installation
100. INSTALL CONSOLE BOX ASSEMBLY (for TMMK Made) Installation
101. INSTALL CONSOLE BOX CARPET Installation
102. INSTALL CONSOLE BOX POCKET Installation
103. INSTALL RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (w/o Navigation System) Installation
104. INSTALL NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (w/ Navigation System) Installation
105. INSTALL INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY Installation
106. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made) Installation
107. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made) Installation
108. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle) Installation
109. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle) Installation
110. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle) Installation
111. INSTALL UPPER CONSOLE PANEL (for Manual Transaxle) Installation
112. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
113. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
114. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation
115. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation
116. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) Installation
117. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) Installation
118. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Installation
119. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
120. INSTALL FRONT DOOR SCUFF PLATE RH Installation
121. INSTALL COMBINATION METER ASSEMBLY (for TMC Made) Installation
122. INSTALL COMBINATION METER ASSEMBLY (for TMMK Made) Installation
123. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1 Installation
124. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System) Installation
125. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System) Installation
126. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Installation
127. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
128. ADJUST SPIRAL CABLE SUB-ASSEMBLY Installation
129. INSTALL STEERING COLUMN COVER (for TMC Made) Installation
130. INSTALL STEERING COLUMN COVER (for TMMK Made) Installation
131. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) Installation
132. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) Installation
133. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
134. INSTALL FRONT DOOR SCUFF PLATE LH Installation
135. INSTALL STEERING WHEEL ASSEMBLY Installation
136. INSTALL STEERING PAD Installation
137. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation
138. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation
139. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat)
140. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)
141. INSPECT FRONT SEAT ASSEMBLY (for Power Seat)
142. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Seat) Programming and Relearning
143. INSPECT STEERING PAD Installation
144. INSPECT SRS WARNING LIGHT Diagnosis System