Installation

2GR-FE ENGINE CONTROL SYSTEM: ECM: INSTALLATION

INSTALLATION

1. INSTALL ECM





(a) Install the ECM bracket with the 4 screws.
Torque: 3.0 Nm (31 kgf-cm, 27in-lbf)
(b) Connect the 2 ECM connectors.
NOTICE: When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and other parts.




(1) Connect the 2 ECM connectors and lower the 2 levers.
NOTICE: Make sure that the 2 levers are securely lowered.





(c) Install the ECM with the 3 nuts.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
2. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY Installation
3. INSTALL WINDSHIELD WIPER MOTOR AND LINK Installation
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
5. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
6. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
7. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Installation
8. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation