Removal

2ZR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL

REMOVAL

1. REMOVE FRONT WIPER ARM HEAD CAP Removal
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal
3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal
4. REMOVE HOOD TO COWL TOP SEAL Removal
5. REMOVE CENTER NO. 1 COWL TOP VENTILATOR LOUVER Removal
6. REMOVE COWL TOP VENTILATOR LOUVER LH Removal
7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal
8. REMOVE OUTER COWL TOP PANEL (for TMC Made) Removal
9. REMOVE OUTER COWL TOP PANEL (except TMC Made) Removal
10. REMOVE NO. 2 CYLINDER HEAD COVER Removal
11. REMOVE AIR FUEL RATIO SENSOR Removal
12. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR





(a) Remove the 4 bolts and No. 1 exhaust manifold heat insulator.
13. REMOVE FRONT EXHAUST PIPE ASSEMBLY





(a) Disconnect the heated oxygen sensor connector.
(b) Remove the 4 bolts and 4 compression springs.
(c) Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.
14. REMOVE MANIFOLD STAY





(a) Remove the 3 bolts and manifold stay.
15. REMOVE EXHAUST MANIFOLD





(a) Remove the 5 nuts and exhaust manifold.
(b) Remove the exhaust manifold gasket.
16. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR





(a) Remove the 3 bolts and No. 2 exhaust manifold heat insulator.