Vehicle Stability Control System

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

DIAGNOSTIC TROUBLE CODE CHART
NOTE: Turn the ignition switch off before removing parts.
HINT:
- If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC.

- When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
- Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

ABS DTC

C0200 - C0215:

C0226 - C1225:

C1235 - C1241:

C1243 - C1361:

C1381 / U0073 - U0124:

*1, *2:
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

- *1:
1 Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
2 Clear the DTCs.

- *2:
1 Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
2 Drive the vehicle at a vehicle speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
3 Repeat the above operation 3 times or more and check that the ABS warning light goes off.
4 Clear the DTCs.
HINT: In some cases, the Techstream cannot be used when the ABS warning light remains on.

VSC DTC