ABS (Antilock Brake System)

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ANTI-LOCK BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

DIAGNOSTIC TROUBLE CODE CHART
NOTE: Turn the ignition switch off before removing parts.
HINT:
- If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC.
- When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
- Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

ABS DTC

C0200 - C0215:

C0226 - C0279:

C1235 - C1239:

C1241 - C1251 / U0073:

*1: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
2. Clear the DTCs.

*2: for 4WD
HINT: In some cases, the Techstream cannot be used when the ABS warning light remains on.

ABS Test Mode DTC

C1271 - C1279:

*2: for 4WD