Diesel Data: Automotive Repair

Installation








AUDIO / VIDEO: RADIO ANTENNA CORD: INSTALLATION

INSTALLATION

1. INSTALL ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)
(a) Install the antenna cord to the roof headlining assembly from the front of the vehicle.





(b) Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
HINT:
- If the tape has lost adhesion, use other tape, such as packing tape, with enough adhesion to secure the antenna cord to the roof headlining assembly.
- For the right corner of the roof headlining assembly, position the marking tape on the antenna cord within the area indicated by the marking line. Secure the antenna cord to the roof headlining assembly with tape as shown in the illustration.
- If the entire length of the antenna cord does not fit, adjust the length by tucking in the cord at the area shown in the illustration.

2. INSTALL ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)
(a) Engage the 3 clamps and install the antenna cord to the roof headlining assembly from the front of the vehicle.





(b) Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
HINT:
- If the tape has lost adhesion, use other tape, such as packing tape, with enough adhesion to secure the antenna cord to the roof headlining assembly.
- For the right corner of the roof headlining assembly, position the marking tape on the antenna cord within the area indicated by the marking line. Secure the antenna cord to the roof headlining assembly with tape as shown in the illustration.
- If the entire length of the antenna cord does not fit, adjust the length by tucking in the cord at the area shown in the illustration.

3. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Installation
4. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Installation
5. INSTALL VISOR HOLDER Installation
6. INSTALL REAR ASSIST GRIP ASSEMBLY Installation
7. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/o Curtain Shield Airbag) Installation
8. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/ Curtain Shield Airbag) Installation
9. INSTALL VISOR ASSEMBLY LH Installation
10. INSTALL VISOR ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.

11. INSTALL SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof) Installation
12. INSTALL NO. 2 ROOM LIGHT ASSEMBLY Installation
13. INSTALL NO. 1 ROOM LIGHT ASSEMBLY Installation
14. INSTALL MAP LIGHT ASSEMBLY (w/o Sliding Roof) Installation
15. INSTALL MAP LIGHT ASSEMBLY (w/ Sliding Roof) Installation
16. INSTALL INNER REAR VIEW MIRROR COVER (w/ EC Mirror) Installation
17. INSTALL ROOF SIDE INNER GARNISH LH Installation
18. INSTALL QUARTER PILLAR GARNISH LH Installation
19. INSTALL SIDE DECK TRIM PANEL ASSEMBLY LH Installation
20. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH Installation
21. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) Installation
22. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side) Installation
23. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation
24. INSTALL REAR SEAT SIDE GARNISH LH Installation
25. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (for LH Side) Installation
26. INSTALL ROOF SIDE INNER GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

27. INSTALL QUARTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

28. INSTALL SIDE DECK TRIM PANEL ASSEMBLY RH (w/o Woofer) Installation
29. INSTALL SIDE DECK TRIM PANEL ASSEMBLY RH (w/ Woofer) Installation
30. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (w/ Woofer) Installation
31. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.

32. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.

33. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH Installation
34. INSTALL REAR SEAT SIDE GARNISH RH Installation
35. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.

36. INSTALL REAR DECK TRIM COVER Installation
37. INSTALL LUGGAGE COMPARTMENT TRAY Installation
38. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR Installation
39. INSTALL DECK FLOOR BOX RH Installation
40. INSTALL DECK FLOOR BOX LH Installation
41. INSTALL JACK ASSEMBLY Installation
42. INSTALL JACK CARRIER ASSEMBLY
43. INSTALL NO. 2 DECK BOARD Installation
44. INSTALL DECK BOARD ASSEMBLY Installation
45. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
46. INSTALL REAR SEATBACK ASSEMBLY RH Installation
47. INSTALL REAR SEATBACK INNER HINGE COVER (for RH Side) Installation
48. INSTALL REAR SEATBACK OUTER HINGE COVER (for RH Side) Installation
49. CONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY Installation
50. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
51. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)
52. INSTALL REAR SEATBACK ASSEMBLY LH Installation
53. INSTALL REAR SEATBACK INNER HINGE COVER (for LH Side) Installation
54. INSTALL REAR SEATBACK OUTER HINGE COVER (for LH Side) Installation
55. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)
56. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
57. INSTALL UPPER CENTER PILLAR GARNISH LH Installation
58. INSTALL LOWER CENTER PILLAR GARNISH LH Installation
59. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
60. INSTALL LAP BELT OUTER ANCHOR COVER (for Driver Side) Installation
61. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
62. INSTALL REAR DOOR SCUFF PLATE LH Installation
63. INSTALL UPPER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

64. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Installation
65. INSTALL LOWER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

66. INSTALL LAP BELT OUTER ANCHOR COVER (for Front Passenger Side) Installation
67. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
68. INSTALL REAR DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.

69. INSTALL RADIO WIRE SUB-ASSEMBLY
(a) Connect the connector and install the radio wire sub-assembly with the bolt.





(b) Engage the 6 clamps.





(c) Engage the claw and install the radio wire connector.
(d) Connect the connector.
70. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation
71. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY Installation
72. INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY Installation
73. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
74. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Installation
75. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Installation
76. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation
77. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation
78. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
79. INSTALL FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag) Installation
80. INSTALL FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag) Installation
81. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
82. INSTALL COWL SIDE TRIM BOARD LH Installation
83. INSTALL FRONT DOOR SCUFF PLATE LH Installation
84. INSTALL FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)
HINT: Use the same procedure for the RH side and the LH side.

85. INSTALL FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag) Installation
86. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
87. INSTALL COWL SIDE TRIM BOARD RH
HINT: Use the same procedure for the RH side and the LH side.

88. INSTALL FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.

89. INSTALL COMBINATION METER ASSEMBLY Installation
90. INSTALL METER HOOD SUB-ASSEMBLY Installation
91. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
92. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
93. ADJUST SPIRAL CABLE Installation
94. INSTALL STEERING WHEEL ASSEMBLY Installation
95. INSTALL STEERING PAD Installation
96. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation
97. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation
98. INSPECT STEERING WHEEL CENTER POINT
99. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
100. INSPECT STEERING PAD Installation
101. INSPECT SRS WARNING LIGHT Diagnosis System