Removal
AUDIO / VIDEO: RADIO ANTENNA CORD: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.
2. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal
3. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal
4. REMOVE STEERING PAD Removal
5. REMOVE STEERING WHEEL ASSEMBLY Removal
6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
8. REMOVE METER HOOD SUB-ASSEMBLY Removal
9. REMOVE COMBINATION METER ASSEMBLY Removal
10. REMOVE FRONT DOOR SCUFF PLATE LH Removal
11. REMOVE COWL SIDE TRIM BOARD LH Removal
12. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal
13. REMOVE FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag) Removal
14. REMOVE FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag) Removal
15. REMOVE FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and LH side.
16. REMOVE COWL SIDE TRIM BOARD RH
HINT: Use the same procedure for the RH side and LH side.
17. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
HINT: Use the same procedure for the RH side and LH side.
18. REMOVE FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)
HINT: Use the same procedure for the RH side and LH side.
19. REMOVE FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag) Removal
20. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal
21. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal
22. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal
23. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Removal
24. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Removal
25. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
26. REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY Removal
27. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY Removal
28. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY Removal
29. REMOVE RADIO WIRE SUB-ASSEMBLY
(a) Disconnect the connector.
(b) Using a screwdriver, disengage the claw and remove the radio wire connector.
HINT: Tape the screwdriver tip before use.
(c) Disconnect the connector and remove the bolt.
(d) Disengage the 6 clamps and remove the radio wire sub-assembly.
30. REMOVE REAR DOOR SCUFF PLATE LH Removal
31. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal
32. REMOVE LAP BELT OUTER ANCHOR COVER (for Driver Side) Removal
33. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal
34. REMOVE LOWER CENTER PILLAR GARNISH LH Removal
35. REMOVE UPPER CENTER PILLAR GARNISH LH Removal
36. REMOVE REAR DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and LH side.
37. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT: Use the same procedure for the RH side and LH side.
38. REMOVE LAP BELT OUTER ANCHOR COVER (for Front Passenger Side) Removal
39. REMOVE LOWER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and LH side.
40. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Removal
41. REMOVE UPPER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and LH side.
42. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
43. REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
44. REMOVE REAR SEATBACK OUTER HINGE COVER (for LH Side) Removal
45. REMOVE REAR SEATBACK INNER HINGE COVER (for LH Side) Removal
46. REMOVE REAR SEATBACK ASSEMBLY LH Removal
47. REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
48. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
49. DISCONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY Removal
50. REMOVE REAR SEATBACK OUTER HINGE COVER (for RH Side) Removal
51. REMOVE REAR SEATBACK INNER HINGE COVER (for RH Side) Removal
52. REMOVE REAR SEATBACK ASSEMBLY RH Removal
53. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
54. REMOVE DECK BOARD ASSEMBLY Removal
55. REMOVE NO. 2 DECK BOARD Removal
56. REMOVE JACK CARRIER ASSEMBLY
57. REMOVE JACK ASSEMBLY Removal
58. REMOVE DECK FLOOR BOX LH Removal
59. REMOVE DECK FLOOR BOX RH Removal
60. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR Removal
61. REMOVE LUGGAGE COMPARTMENT TRAY Removal
62. REMOVE REAR DECK TRIM COVER Removal
63. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY (for LH Side) Removal
64. REMOVE REAR SEAT SIDE GARNISH LH Removal
65. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Removal
66. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side) Removal
67. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) Removal
68. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH Removal
69. REMOVE SIDE DECK TRIM PANEL ASSEMBLY LH Removal
70. REMOVE QUARTER PILLAR GARNISH LH Removal
71. REMOVE ROOF SIDE INNER GARNISH LH Removal
72. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY (for RH Side)
HINT: Use the same procedure for the RH side and LH side.
73. REMOVE REAR SEAT SIDE GARNISH RH Removal
74. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH Removal
75. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for RH Side)
76. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)
HINT: Use the same procedure for the RH side and LH side.
77. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH (w/ Woofer) Removal
78. REMOVE SIDE DECK TRIM PANEL ASSEMBLY RH (w/o Woofer) Removal
79. REMOVE SIDE DECK TRIM PANEL ASSEMBLY RH (w/ Woofer) Removal
80. REMOVE QUARTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and LH side.
81. REMOVE ROOF SIDE INNER GARNISH RH
HINT: Use the same procedure for the RH side and LH side.
82. REMOVE INNER REAR VIEW MIRROR COVER (w/ EC Mirror) Removal
83. REMOVE MAP LIGHT ASSEMBLY (w/o Sliding Roof) Removal
84. REMOVE MAP LIGHT ASSEMBLY (w/ Sliding Roof) Removal
85. REMOVE NO. 1 ROOM LIGHT ASSEMBLY Removal
86. REMOVE NO. 2 ROOM LIGHT ASSEMBLY Removal
87. REMOVE SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof)
88. REMOVE VISOR ASSEMBLY LH Removal
89. REMOVE VISOR ASSEMBLY RH
HINT: Use the same procedure for the RH side and LH side.
90. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY (w/o Curtain Shield Airbag) Removal
91. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY (w/ Curtain Shield Airbag) Removal
92. REMOVE REAR ASSIST GRIP ASSEMBLY Removal
93. REMOVE VISOR HOLDER Removal
94. REMOVE ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Removal
95. REMOVE ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Removal
96. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)
(a) Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.
HINT: Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.
(b) Pull out the antenna cord from the slit and then remove the antenna cord from the roof headlining.
97. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)
(a) Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.
HINT: Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.
(b) Pull out the antenna cord from the slit.
(c) Disengage the 3 clamps and remove the antenna cord from the roof headlining.