Installation

2AZ-FE ENGINE MECHANICAL: ENGINE UNIT: INSTALLATION

INSTALLATION

1. INSTALL RADIO SETTING CONDENSER





(a) Install the condenser with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL ENGINE COOLANT TEMPERATURE SENSOR Installation
3. INSTALL OIL PRESSURE SWITCH Installation
4. INSTALL KNOCK SENSOR Installation
5. INSTALL IGNITION COIL ASSEMBLY Installation
6. INSTALL NO. 1 WATER BY-PASS PIPE





(a) Install a new gasket and the pipe with the bolt and 2 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
7. INSTALL ENGINE OIL DIPSTICK GUIDE Installation
8. INSTALL ENGINE OIL DIPSTICK
9. INSTALL THERMOSTAT Installation
10. INSTALL INLET WATER Installation
11. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY Installation
12. INSTALL NO. 2 MANIFOLD STAY Installation
13. INSTALL MANIFOLD STAY Installation
14. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation
15. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR





(a) Install the No. 1 intake manifold insulator onto the cylinder block.
16. INSTALL INTAKE MANIFOLD Installation
17. INSTALL FUEL INJECTOR ASSEMBLY Installation
18. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY Installation