Removal

U140F AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSAXLE ASSEMBLY: REMOVAL

REMOVAL

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT: See the steps from "Discharge Fuel System Pressure" through "Engine Assembly with Transaxle" Removal.

2. INSTALL ENGINE HANGERS Removal
3. REMOVE DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT





(a) Remove the flywheel housing under cover.
(b) Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.
HINT: There will be one black colored bolt.

4. REMOVE FRONT ENGINE MOUNTING INSULATOR Removal
5. REMOVE REAR ENGINE MOUNTING INSULATOR Removal
6. REMOVE STARTER ASSEMBLY Removal
7. DISCONNECT WIRE HARNESS





(a) Disconnect the park/neutral position switch connector.
(b) Disconnect the transmission wire connector.
(c) Disconnect the 2 speed sensor connectors.
(d) Disconnect the 5 wire harness clamps.





(e) Remove the bolt and wire harness bracket.
(f) Remove the bolt and transmission control cable support.
8. REMOVE REAR ENGINE MOUNTING BRACKET





(a) Remove the 2 bolts and mounting bracket.
9. REMOVE FRONT ENGINE MOUNTING BRACKET





(a) Remove the 3 bolts and mounting bracket.
10. REMOVE ENGINE MOUNTING BRACKET LH





(a) Remove the 3 bolts and mounting bracket.
11. REMOVE TRANSFER STIFFENER PLATE RH Removal
12. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY





(a) Remove the 4 lower side mounting bolts.





(b) Remove the 5 upper side mounting bolts.
(c) Separate and remove the automatic transaxle.
13. REMOVE TRANSFER ASSEMBLY Removal
14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET





(a) Remove the 2 bolts and No. 1 transmission control cable bracket.
15. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY





(a) Remove the transmission oil level gauge sub-assembly.
(b) Remove the bolt and transmission oil filler tube sub-assembly.
(c) Remove the O-ring from the transmission oil filler tube sub-assembly.
16. REMOVE OIL COOLER TUBE





(a) Remove the 2 hose clamps, bolt and oil cooler tube.
17. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY





(a) Remove the bolt and hole cover from the transaxle case.
(b) Remove the O-ring from the hole cover.
18. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY
(a) Remove the torque converter clutch from the automatic transaxle.