Disassembly

BRAKE (FRONT): FRONT BRAKE: DISASSEMBLY

DISASSEMBLY

1. REMOVE CYLINDER BOOT





(a) Using a screwdriver, remove the set ring and cylinder boot from the disc brake cylinder.
NOTE: Be careful not to damage the brake piston or cylinder.
HINT: Tape the screwdriver tip before use.

2. REMOVE FRONT DISC BRAKE PISTON





(a) Place a piece of cloth between the piston and disc brake cylinder.
(b) Apply compressed air to remove the piston from the disc brake cylinder.
CAUTION: Do not place your fingers in front of the piston when using compressed air.
NOTE: Do not allow any brake fluid to spatter.

3. REMOVE PISTON SEAL





(a) Using a screwdriver, remove the piston seal from the disc brake cylinder.
NOTE: Do not damage the inner surface or piston seal groove of the cylinder.
HINT: Tape the screwdriver tip before use.

4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
5. REMOVE FRONT DISC BRAKE BLEEDER PLUG