Removal
2ZR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL
REMOVAL
1. REMOVE FRONT WIPER ARM HEAD CAP Removal
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal
3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal
4. REMOVE HOOD TO COWL TOP SEAL Removal
5. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
6. REMOVE COWL TOP VENTILATOR LOUVER LH Removal
7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal
8. REMOVE OUTER COWL TOP PANEL Removal
9. REMOVE AIR FUEL RATIO SENSOR Removal
10. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
(a) Remove the 4 bolts and No. 1 exhaust manifold heat insulator.
11. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disconnect the heated oxygen sensor connector.
(b) Remove the 4 bolts and 4 compression springs.
(c) Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.
(d) Remove the 2 gaskets.
12. REMOVE MANIFOLD STAY
(a) Remove the 3 bolts and manifold stay.
13. REMOVE EXHAUST MANIFOLD
(a) Remove the 5 nuts and exhaust manifold.
(b) Remove the exhaust manifold gasket.
14. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
(a) Remove the 3 bolts and No. 2 exhaust manifold heat insulator.