Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: REMOVAL
REMOVAL
1. PRECAUTION
CAUTION: Be sure to read Precaution thoroughly before servicing Service Precautions.
2. POSITION FRONT WHEELS STRAIGHT AHEAD
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
4. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal
5. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal
6. REMOVE STEERING PAD Removal
7. REMOVE STEERING WHEEL ASSEMBLY Removal
8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal
10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal
11. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal
12. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Removal
13. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Removal
14. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
15. REMOVE FRONT UPPER CONSOLE BOX Removal
16. REMOVE NO. 2 SWITCH HOLE BASE Removal
17. REMOVE CONSOLE BOX CARPET
18. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 2WD) Removal
19. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 4WD) Removal
20. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal
21. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal
22. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle) Removal
23. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Removal
24. REMOVE NO. 1 SWITCH HOLE BASE Removal
25. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal
26. REMOVE HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch and Cruise Control System)
(a) Disconnect the connector and remove the horn button wire sub-assembly.
27. REMOVE LOWER STEERING COLUMN COVER Removal
28. REMOVE UPPER STEERING COLUMN COVER Removal
29. REMOVE SPIRAL CABLE (w/o VSC)
(a) Disconnect the connectors from the spiral cable.
NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(b) Disengage the 3 claws and remove the spiral cable.
30. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC)
(a) Disconnect the connectors from the spiral cable with steering angle sensor.
NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(b) Disengage the 3 claws and remove the spiral cable with steering angle sensor.
31. REMOVE SPIRAL CABLE (w/ VSC)
(a) Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.