Installation
WIPER / WASHER: REAR WIPER MOTOR: INSTALLATION
INSTALLATION
1. INSTALL REAR WIPER MOTOR ASSEMBLY
(a) Install the rear wiper motor assembly with the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Connect the connector.
2. INSTALL REAR WIPER MOTOR GROMMET
(a) Apply MP grease to the entire surface of the wiper motor grommet lip.
HINT: Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.
(b) Install the wiper motor grommet.
3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
(a) Stop the wiper motor at the automatic stop position.
(b) When reusing the rear wiper arm and blade assembly:
(1) Clean the wiper arm serrations.
(c) When reusing the rear wiper motor assembly:
(1) Clean the wiper pivot serrations with a wire brush.
(d) Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
HINT:
- Hold down the arm hinge by hand while tightening the nut.
- Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.
4. INSTALL REAR WIPER ARM HEAD CAP
(a) Engage the 2 pins.
(b) Engage the 2 pins to install the rear wiper arm head cap as shown in the illustration.
HINT: Push down on the cap until a click sound can be heard.
(c) Operate the rear wiper while spraying washer fluid on the glass. Make sure that the rear wiper functions properly and there is no interference with the vehicle body.
5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Reassembly
6. INSTALL BACK DOOR SIDE GARNISH LH Reassembly
7. INSTALL BACK DOOR SIDE GARNISH RH Reassembly
8. INSTALL BACK DOOR CENTER GARNISH Reassembly