Installation

2AZ-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

INSTALLATION

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY





(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Using a 24 mm deep socket wrench, install the oil pressure switch.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTE: Do not start the engine for at least 1 hour after installation.

(c) Connect the oil pressure switch connector.
2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Installation
3. INSPECT FOR OIL LEAK