Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL Disassembly
3. REMOVE FRONT ARMREST UPPER BASE PANEL Disassembly
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
5. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly
6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Front No. 2 Speaker) Disassembly
7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Front No. 2 Speaker) Disassembly
8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP Disassembly
9. REMOVE FRONT DOOR SERVICE HOLE COVER (w/o Power Door Lock) Disassembly
10. REMOVE FRONT DOOR SERVICE HOLE COVER (w/ Power Door Lock) Disassembly
11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly
12. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly
13. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY





(a) Using a "TORX" driver (T25), remove the 3 screws and the front power window regulator motor assembly.