Display Signal Circuit Between Multi-Display and Television Camera Assembly

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: Display Signal Circuit between Multi-display and Television Camera Assembly

Display Signal Circuit between Multi-display and Television Camera Assembly

DESCRIPTION

This is the display signal circuit of the television camera.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK TELEVISION CAMERA ASSEMBLY
(a) Check the waveform of the camera using an oscilloscope.
OK:
Waveform is as shown in the illustration.













NG -- REPAIR TELEVISION CAMERA ASSEMBLY
OK -- Continue to next step.

2. CHECK WIRE HARNESS (MULTI-DISPLAY - TELEVISION CAMERA)




(a) Disconnect the M14 display connector.
(b) Disconnect the T13 camera connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE