Removal

AUDIO / VISUAL: FRONT DOOR SPEAKER: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH sides.
- The procedures listed below are for the LH side.

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH Disassembly
2. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY





(a) Detach the 3 claws and remove the speaker.
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH Disassembly
4. REMOVE DOOR PULL HANDLE Disassembly
5. REMOVE FRONT ARMREST BASE PANEL UPPER LH Disassembly
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH Disassembly
7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY





(a) Disconnect the connector.
(b) Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.
NOTICE:
- Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
- Be careful. The cut rivet is very hot.

(c) Continue drilling and push out the remaining rivet fragments.
(d) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.