Disassembly
ENGINE HOOD / DOOR: BACK DOOR: DISASSEMBLY
DISASSEMBLY
1. REMOVE NO. 2 REAR FLOOR BOARD
2. REMOVE REAR DECK FLOOR BOX
3. REMOVE NO. 3 REAR FLOOR BOARD
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
5. REMOVE REAR WIPER ARM ASSEMBLY Removal
6. REMOVE BACK DOOR LOWER TRIM BOARD ASSEMBLY
(a) Using a screwdriver, detach the 11 clips and remove the lower trim board.
HINT: Tape the screwdriver tip before use.
7. REMOVE BACK DOOR UPPER TRIM BOARD ASSEMBLY
(a) Using a screwdriver, detach the 5 clips and remove the upper trim board.
HINT: Tape the screwdriver tip before use.
8. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY
(a) Using a screwdriver, detach the 5 clips and remove the trim panel.
HINT: Tape the screwdriver tip before use.
9. REMOVE BACK DOOR SIDE GARNISH LH
(a) Using a screwdriver, detach the 3 clips and remove the garnish.
HINT: Tape the screwdriver tip before use.
10. REMOVE BACK DOOR SIDE GARNISH RH
(a) Using a screwdriver, detach the 3 clips and remove the garnish.
HINT: Tape the screwdriver tip before use.
11. REMOVE REAR WIPER MOTOR ASSEMBLY Removal
12. REMOVE REAR SPOILER SUB-ASSEMBLY Removal
13. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
14. REMOVE TELEVISION CAMERA ASSEMBLY
(a) Remove the 2 screws.
(b) Disconnect the connector and remove the camera.
15. REMOVE LICENSE PLATE LIGHT ASSEMBLY Removal
16. REMOVE BACK DOOR LOCK STRIKER ASSEMBLY
(a) Using a screwdriver, detach the 2 claws and remove the cover.
(b) Using a T40 "torx" wrench, remove the 2 screws and remove the cover.
17. REMOVE BACK DOOR STAY ASSEMBLY LH Removal
18. REMOVE BACK DOOR STAY ASSEMBLY RH
HINT: Use the same procedures for the LH side.
19. REMOVE REAR DECK TRIM COVER Removal
20. REMOVE BACK DOOR LOCK ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 3 bolts and door lock.
21. REMOVE BACK DOOR LOWER STOPPER
(a) Remove the 2 bolts and stopper LH and RH.