Parking Brake System: Adjustments

PARKING BRAKE: PARKING BRAKE SYSTEM: ADJUSTMENT

ADJUSTMENT

1. REMOVE REAR WHEEL
2. ADJUST PARKING BRAKE SHOE CLEARANCE Installation
3. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. CHECK PARKING BRAKE PEDAL TRAVEL
(a) Firmly depress the parking brake pedal.
(b) Release the parking brake.
(c) Slowly depress the parking brake pedal all the way again and count the number of clicks.
Standard parking brake pedal travel:
6 to 9 clicks at 300 N (31 kgf)
5. ADJUST PARKING BRAKE PEDAL TRAVEL
(a) Remove the rear console box Removal.
HINT: Refer to the procedures from the removal of the upper console panel sub-assembly up until the removal of the rear console box sub-assembly.

(b) Remove the front floor footrest Removal.
(c) Remove the 8 bolts and front floor crossmember reinforcement LH.





(d) Slide the cover to the rear of the vehicle as shown in the illustration.





(e) Depress the parking brake pedal 5 clicks. Hold the adjusting nut using a wrench and loosen the lock nut.
(f) Release the parking brake.
(g) Turn the lock nut and adjusting nut until parking brake travel is within the specified range.
Torque: 12.5 Nm (127 kgf-cm, 9 ft-lbf)
(h) Count the number of clicks after depressing and releasing the parking brake pedal 3 to 4 times.
(i) Check whether the parking brake drags or not.
(j) When operating the parking brake pedal, check that the parking brake pedal indicator light comes on.





(k) Return the cover to the original position as shown in the illustration.
(l) Install the front floor crossmember reinforcement LH with the 8 bolts.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
(m) Install the front floor footrest Installation.
(n) Install the rear console box Installation.
HINT: Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the upper console panel sub-assembly.