Installation

P112 HYBRID BATTERY CONTROL: BATTERY ECU: INSTALLATION

INSTALLATION

1. INSTALL BATTERY ECU
CAUTION: Wear insulating gloves.

(a) Install the battery ECU with the 2 screws.
Torque: 3.3 Nm (34 kgf-cm, 29 in-lbf)





(b) Install the aluminum shield wire of the main battery cable together with the battery ECU with a new nut.
Torque: 3.3 Nm (34 kgf-cm, 29 in-lbf)
(c) Connect the clamp and No. 2 frame wire connector.
(d) Connect the thermistor connector.





(e) Connect the system main relay connector.
2. INSTALL JUNCTION TERMINAL Installation
3. INSTALL NO. 6 BATTERY CARRIER PANEL Installation
4. INSTALL BATTERY CARRIER BRACKET Installation
5. INSTALL DECK TRIM SIDE PANEL LH Installation
6. INSTALL DECK FLOOR BOX LH Installation
7. INSTALL REAR NO. 4 FLOOR BOARD Installation
8. INSTALL REAR SIDE SEAT BACK FRAME LH Installation
9. INSTALL REAR NO. 1 FLOOR BOARD Installation
10. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
11. INSTALL TONNEAU COVER Installation
12. INSTALL REAR DECK TRIM COVER Installation
13. INSTALL SERVICE PLUG GRIP Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation
15. INSTALL REAR NO. 3 FLOOR BOARD Installation
16. INSTALL REAR DECK FLOOR BOX Installation
17. INSTALL REAR NO. 2 FLOOR BOARD Installation
18. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.