Installation

INSTRUMENT PANEL: LOWER INSTRUMENT PANEL: INSTALLATION

INSTALLATION

1. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
(a) Install the instrument panel.
(b) Connect all the connectors and attach all the clamps.
(c) Install the 2 screws.
(d) Install the 6 bolts.
(e) Install the 8 clips to the duct and lower instrument panel.





2. INSTALL SHIFT LEVER ASSEMBLY LOWER
3. INSTALL POWER STEERING ECU





4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
(a) Attach the 2 claws to install the instrument panel under cover.





5. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER
(a) Attach the 4 claws to install the instrument panel finish panel.





6. INSTALL GLOVE COMPARTMENT DOOR LOCK ASSEMBLY
(a) Install the glove compartment door lock with the 4 screws.





7. INSTALL GLOVE COMPARTMENT DOOR LOCK COVER
(a) Attach the 6 claws to install the glove compartment door lock cover.





8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER
(a) Attach the 4 claws and 2 clips to install the instrument panel finish panel.
(b) Install the clip.
9. INSTALL RADIO RECEIVER
10. INSTALL NO. 1 CENTER CLUSTER CUSHION





11. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
(a) Attach the 4 claws and 2 clips to install the instrument cluster finish panel.
(b) Install the 2 screws.
12. INSTALL COWL SIDE TRIM BOARD LH Installation
13. INSTALL COWL SIDE TRIM BOARD RH Installation
14. INSTALL FRONT DOOR SCUFF PLATE LH Installation
15. INSTALL FRONT DOOR SCUFF PLATE RH Installation
16. INSTALL SPIRAL CABLE SUB-ASSEMBLY Installation
17. INSTALL STEERING COLUMN COVER Installation
18. INSTALL TILT LEVER BRACKET Installation
19. INSTALL STEERING WHEEL ASSEMBLY Installation
20. INSTALL STEERING PAD ASSEMBLY Installation
21. INSTALL NO. 3 STEERING WHEEL COVER LOWER
22. INSTALL NO. 2 STEERING WHEEL COVER LOWER
23. INSTALL INSTRUMENT PANEL SAFETY PAD
(a) Install the instrument panel Installation.
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
25. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

26. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.