Driver Side Seat Belt Warning Light Does Not Operate

METER: METER / GAUGE SYSTEM: Driver Side Seat Belt Warning Light does not Operate

Driver Side Seat Belt Warning Light does not Operate

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (BUCKLE SWITCH)




(a) Remove the front seat inner belt LH.
(b) Measure the resistance of the buckle switch.
Standard resistance:






NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
OK -- Continue to next step.

2. CHECK WIRE HARNESS (INNER BELT LH - METER AND BODY GROUND)




(a) Disconnect the B15 belt connector.
(b) Disconnect the C10 meter connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY