Operation Check

LIGHTING: LIGHTING SYSTEM: OPERATION CHECK

OPERATION CHECK

1. CHECK ILLUMINATED ENTRY OPERATION
(a) Illumination entry system controls the following:
- Key slot light
- No. 1 room light

(b) Check that the lights turn on after:
(1) Unlocking driver or front passenger door that was closed and locked with the power switch OFF.
(c) Check that the lights fade out after:
(1) Leaving the doors unlocked for 15 seconds.
(2) Turning the power switch ON (ACC or IG).
(3) Locking all the doors.
(d) Check that the lights stay on for at least 15 seconds after opening any of the doors, then fade out again after 15 seconds.
(e) Check that the lights turn on after:
(1) Closing all the doors and turning the power switch from ON (ACC or IG) to OFF.
(f) Check that the lights fade out after:
(1) Leaving the doors unlocked for 15 seconds.
(2) Turning the power switch ON (ACC or IG).
(3) Locking all the doors.
(g) Check that the lights stay on for at least 15 seconds after opening any of the doors, then fade out again in 15 seconds after closing all the doors.
(h) Check that the lights turn on when opening any of the doors and fade out after either closing and locking them or turning the power switch ON (ACC or IG).
2. CHECK CONLIGHT SYSTEM OPERATION
(a) Turn the power switch ON (IG).
(b) Turn the headlight dimmer switch to the AUTO position.
(c) Cover the automatic light control sensor and check that the taillight and headlight turn on in order.
(d) Uncover the automatic light control sensor and check that the headlight and taillight go off in order.
3. CHECK LIGHT AUTO TURN OFF SYSTEM OPERATION
HINT: Perform the operation check at a location with bright surroundings.

(a) Turn the power switch ON (IG), and switch the light control switch into the TAIL or HEAD position when driver side door is closed.
(b) Turn the power switch OFF and open the driver's door. Check that the headlight, taillight, and front fog light go off.
(c) Turn the power switch ON (IG) and switch the light control switch into the AUTO position.
(d) Turn the power switch OFF and open the driver's door when the light control switch is in the AUTO position and headlights remain on by the conlight system operation. Check that the headlight, taillight, front fog light go off.
4. CHECK BATTERY SAVER OPERATION
(a) Check that the all lights go off after approximately 20 minutes with the power switch OFF and driver door opened.
5. CHECK DAYTIME RUNNING LIGHT OPERATION
(a) Turn the light control switch off, and release the parking brake with the power switch ON (IG or READY). Check that the headlight (low beam) dims.
(b) Check that the daytime running light goes off after turning the power switch OFF or changing the light control switch to the HEAD position.
(c) Check that the headlight (low beam) dims when releasing the parking brake under the following conditions:
- Light control switch is in the AUTO position (with bright surroundings).
- Conlight system is not operating.
- Power switch is ON (IG).
- Power switch is ON (READY).

(d) Turn the power switch OFF or change the light control switch to the TAIL or HEAD position. Check that the headlight (low beam) goes off.