Removal

1NZ-FXE EMISSION CONTROL: TRAP CANISTER: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal
2. REMOVE REAR NO. 2 FLOOR BOARD Removal
3. REMOVE REAR DECK FLOOR BOX Removal
4. REMOVE REAR NO. 3 FLOOR BOARD Removal
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

6. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL Removal
7. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
8. REMOVE REAR FLOOR SERVICE HOLE COVER Removal
9. REMOVE FRONT FLOOR PANEL BRACE Removal
10. REMOVE FRONT EXHAUST PIPE Removal
11. REMOVE FUEL TANK SUB-ASSEMBLY Removal
12. REMOVE TRAP CANISTER WITH PUMP MODULE





(a) Remove the clamp from the fuel tank vent hose and canister hose.
(b) Remove the tube of the fuel tank main tube from the clamp.
(c) Remove the tube of the fuel tank to canister tube from the clamp.
(d) Remove the tube of the fuel tank vent hose from the 2 fuel tube with No. 1 grommet clamps.





(e) Disconnect the canister pump module connector.
(f) Remove the 2 bolts, then remove the trap canister with pump module and ground terminal of the fuel tank wire.





(g) Remove the gasket from the fuel tank.





(h) Remove the 2 clamps from the trap canister with pump module.





(i) Pinch the retainer and pull out the fuel tank vent connector with the fuel tank vent hose connector pushed to the fuel tank vent hose side to disconnect the fuel tank vent hose from the trap canister with pump module.
NOTICE:
- Remove dirt or foreign objects on the fuel tank vent hose connector before this work procedure.
- Do not allow any scratches or foreign objects on the parts when disconnecting them as the fuel tank vent hose connector has the O-ring that seals the pipe.
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the nylon tube.
- Protect the connecting part by covering it with a plastic bag after disconnecting the fuel tank vent hose.
- If the fuel tank vent hose connector and pipe are stuck, push and pull them to release them.