Installation

POWER STEERING: STEERING GEAR: INSTALLATION

INSTALLATION

1. INSTALL STEERING GEAR ASSEMBLY





(a) Install the steering gear from the left side of the vehicle.
HINT: Be careful not to hit the stabilizer bar when installing the steering gear.

(b) Install the No. 1 column hole cover to the steering gear.
(c) Install the steering gear to the crossmember with the 4 bolts.
Torque: 58 Nm (591 kgf-cm, 43 ft-lbf)
2. INSTALL STEERING INTERMEDIATE SHAFT





(a) Move the No. 1 column hole cover to the upper side of the vehicle, align the matchmarks, and install the intermediate shaft from the inside of the vehicle.
NOTE: Do not damage the No. 1 hole cover when moving it.

(b) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
(c) Fit the recessed part on the No. 1 column hole cover to the steering gear.
NOTE: Make sure that the No. 1 hole cover is securely installed.

3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH Installation
4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT: Use the same procedures described for the LH side.

5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation
6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

7. CONNECT NO. 1 TIE ROD END SUB-ASSEMBLY Installation
8. CONNECT NO. 2 TIE ROD END SUB-ASSEMBLY
HINT: Use the same procedures described for the No. 1 tie rod end.

9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
10. INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY





(a) Install the clip labeled B to the vehicle body and install the No. 1 column hole cover to the vehicle body with the clip labeled A.
NOTE: Make sure that the lip of the No. 1 hole cover fits on the dash panel correctly.

11. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
12. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY





(a) Align the matchmarks and install the sliding yoke to the intermediate shaft with the bolt labeled B.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
(b) Tighten the bolt labeled A.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
13. INSTALL COLUMN HOLE COVER SILENCER SHEET
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment Service and Repair.
16. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
HINT:
Programming and Relearning.