Installation

SUSPENSION: FRONT STABILIZER BAR: INSTALLATION

INSTALLATION

1. INSTALL FRONT STABILIZER BAR
(a) Insert the front stabilizer bar from the right side of the vehicle.
2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH





(a) Install the bush to the outer side of the bush stopper on the stabilizer bar.
NOTICE:
- Place the cutout of the stabilizer bush facing the rear side.
- Ensure the right and left deviation of the stabilizer bar is 5 mm (0.20 in.) or less.

3. INSTALL STEERING GEAR ASSEMBLY Installation
4. INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY Installation
5. INSTALL STEERING INTERMEDIATE SHAFT Installation
6. CONNECT FRONT NO. 1 STABILIZER BRACKET LH
(a) Install the No. 1 stabilizer bracket the front suspension crossmember with the 2 bolts.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
7. CONNECT FRONT NO. 1 STABILIZER BRACKET RH
HINT: Install the RH side following the same procedures as the LH side.

8. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
9. INSTALL FLOOR PANEL BRACE FRONT Installation
10. INSTALL FRONT STABILIZER LINK ASSEMBLY LH





(a) Install the front stabilizer link LH with the 2 nuts.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT: Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.

11. INSTALL NO. 2 TIE ROD END SUB-ASSEMBLY Installation
12. INSTALL NO. 1 TIE ROD END SUB-ASSEMBLY Installation
13. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment Service and Repair.