Removal

SUSPENSION: FRONT STABILIZER BAR: REMOVAL

REMOVAL

1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. REMOVE COLUMN HOLE COVER SILENCER SHEET Removal
3. DISCONNECT STEERING SLIDING YOKE SUB-ASSEMBLY Removal
4. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY Removal
5. REMOVE FRONT WHEEL
6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH





(a) Remove the 2 nuts and front stabilizer link LH.
HINT: Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.

7. DISCONNECT NO. 2 TIE ROD END SUB-ASSEMBLY Removal
8. DISCONNECT NO. 1 TIE ROD END SUB-ASSEMBLY Removal
9. REMOVE FLOOR PANEL BRACE FRONT Removal
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
11. DISCONNECT FRONT NO. 1 STABILIZER BRACKET LH
(a) Remove the 2 bolts and the No. 1 stabilizer bracket from the front suspension crossmember.
12. DISCONNECT FRONT NO. 1 STABILIZER BRACKET RH
HINT: Remove the RH side following the same procedures as the LH side.

13. REMOVE STEERING INTERMEDIATE SHAFT Removal
14. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
15. REMOVE STEERING GEAR ASSEMBLY Removal
16. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
(a) Remove the 2 front No. 1 stabilizer bar bushes from the stabilizer bar.
17. REMOVE FRONT STABILIZER BAR
(a) Remove the front stabilizer bar from the right side of the vehicle.