Removal

AXLE: REAR AXLE HUB AND BEARING: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
3. DISCONNECT SKID CONTROL SENSOR CONNECTOR
NOTE: Be careful that foreign matter does not attach to the inside of the skid control sensor connector and on the installation portion.

4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH





(a) Remove the 4 bolts and then remove the axle hub and bearing.