Installation

WIPER AND WASHER: REAR WIPER MOTOR: INSTALLATION

INSTALLATION





1. INSTALL REAR WIPER MOTOR ASSEMBLY
(a) Install the rear wiper motor with the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Connect the connector.
2. INSTALL BACK DOOR LOWER TRIM BOARD ASSEMBLY Reassembly
3. INSTALL REAR WIPER ARM ASSEMBLY





(a) Stop the wiper motor at the automatic stop position.
(b) Clean the wiper arm serration with a round file or equivalent.
(c) Clean the wiper pivot serration with a wire brush.





(d) Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
HINT:
- Hold down the arm hinge by hand while installing the nut.
- Install the arm and blade so that the rear wiper blade is aligned with the defogger line.

(e) Install the cap.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.