Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Connect the driver side knee airbag connector to the driver side knee airbag assembly.

Text in Illustration





NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.

(d) Connect the DLC3 to the driver side knee airbag assembly with the 2 claws.





(e) Temporarily install the driver side knee airbag assembly with the 2 hooks.
(f) Install the driver side knee airbag assembly with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
4. INSTALL FRONT DOOR SCUFF PLATE LH Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check DTC Check / Clear.
7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.