Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly
3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly
6. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly
7. REMOVE REAR DOOR GLASS RUN Disassembly
8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly
9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly
10. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY Disassembly
11. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY





(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.