Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly
3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly
4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Removal
5. REMOVE COURTESY LIGHT ASSEMBLY Removal
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
7. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly
8. REMOVE DOOR SIDE AIR BAG SENSOR Removal
9. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly
10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly
11. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY Disassembly
12. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY





(a) Using a T25 "TORX" driver, remove the 3 screws and the front power window regulator motor assembly.