Pinout Values and Diagnostic Parameters

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF SYSTEM: TERMINALS OF ECU

TERMINALS OF ECU

1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
(a) Disconnect the P4 ECU connector.





(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disconnected.





If the result is not as specified, there may be a malfunction in the wire harness.
(c) Reconnect the P4 ECU connector.
(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the sliding roof ECU (sliding roof drive gear sub-assembly) may have a malfunction.