Removal

HEATING / AIR CONDITIONING: COMPRESSOR (for 1AR-FE): REMOVAL

REMOVAL

1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT WHEEL RH
4. REMOVE NO. 1 ENGINE UNDER COVER
5. SEPARATE FRONT FENDER LINER RH
6. REMOVE FRONT FENDER APRON RH Removal
7. REMOVE V-RIBBED BELT Removal
8. REMOVE RADIATOR ASSEMBLY
HINT: Refer to the procedure for Remove Radiator Assembly Removal.

9. DISCONNECT COOLER REFRIGERANT DISCHARGE HOSE





(a) Disengage each clamp.
(b) Disconnect each connector.





(c) Using pliers, grip the claws of the clip and slide the clip to remove the No. 2 radiator hose.





(d) Remove the bolt and disconnect the cooler refrigerant discharge hose from the compressor assembly with pulley.
(e) Remove the O-ring from the discharge hose.
NOTICE: Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

10. DISCONNECT SUCTION HOSE SUB-ASSEMBLY





(a) Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
(b) Remove the O-ring from the suction hose sub-assembly.
NOTICE: Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

11. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY





(a) Remove the 2 bolts, 2 nuts and compressor assembly with pulley.





(b) Remove the 2 stud bolts.