Replacement

U660E AUTOMATIC TRANSMISSION / TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT

REPLACEMENT

1. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the No. 2 engine under cover and front fender apron LH.

(b) Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the automatic transaxle.

(d) Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle.
(e) Drain automatic transaxle fluid from the automatic transaxle.

(f) Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.
Torque: 1.7 Nm (17 kgf-cm, 15in-lbf)

(g) Using a 6 mm socket hexagon wrench, install a new gasket and the overflow plug to the automatic transaxle.
Torque: 40 Nm (408 kgf-cm, 30ft-lbf)

(h) Install a new gasket and the refill plug to the automatic transaxle.
Torque: 49 Nm (500 kgf-cm, 36ft-lbf)
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY
HINT: Removal

3. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the transaxle case oil seal.
SST: 09308-00010
4. REMOVE FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the front transaxle case oil seal.
SST: 09308-00010
5. INSTALL TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, tap in a new transaxle case oil seal.
SST: 09316-10010
SST: 09950-70010
09951-07100
Oil seal driven in depth:
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTICE: Check that the oil seal is installed in the correct direction.

(b) Coat the lip of the transaxle case oil seal with MP grease.
6. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, tap in a new front transaxle case oil seal.
SST: 09316-60011
09316-00011
Oil seal driven in depth:
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTICE: Check that the oil seal is installed in the correct direction.

(b) Coat the lip of the front transaxle case oil seal with MP grease.
7. INSTALL FRONT DRIVE SHAFT ASSEMBLY
HINT: Installation

8. ADD AUTOMATIC TRANSAXLE FLUID
HINT: Procedures