Disassembly

ENGINE HOOD / DOOR: BACK DOOR (for Hatchback): DISASSEMBLY

DISASSEMBLY

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE CENTER STOP LIGHT COVER Removal
3. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY Removal
4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY





(a) Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.





(b) Disengage the 3 claws and 9 clips and remove the back door trim board.
5. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY Removal
6. REMOVE REAR WIPER MOTOR GROMMET Removal
7. REMOVE REAR WIPER MOTOR Removal





8. REMOVE BACK DOOR PANEL NO.2 PROTECTOR
(a) Disengage the claw and clip, then remove back door panel protector No. 2.
NOTE: Remove any tape remaining on the back door side.

9. REMOVE BACK DOOR PANEL NO.1 PROTECTOR
HINT: Use the same procedure as described for the No. 2 side.

10. REMOVE BACK DOOR LOCK ASSEMBLY Removal





11. REMOVE BACK DOOR LOCK CYLINDER ASSEMBLY
(a) Remove the bolt and back door lock cylinder assembly.





12. REMOVE BACK DOOR OUTSIDE HANDLE
(a) Remove the back door outside handle from the back door panel.





13. REMOVE BACK DOOR LOCK ACTUATOR ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 2 bolts and the back door lock actuator.
14. REMOVE REAR SPOILER COVER LH Removal
15. REMOVE REAR SPOILER COVER RH Removal
16. REMOVE REAR SPOILER Removal
17. REMOVE NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE Removal
18. REMOVE NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE Removal
19. REMOVE SYMBOL EMBLEM Removal