ABS (Antilock Brake System) (for Sedan)

BRAKE CONTROL: ANTI-LOCK BRAKE SYSTEM (for Sedan): DTC CHECK / CLEAR

DTC CHECK / CLEAR

1. DTC CHECK (USING TECHSTREAM)
(a) Check DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the tester on.
(4) Read the DTCs using the Techstream.
Select the following menu items: Chassis / ABS/VSC/TRAC/ DTC.
2. DTC CLEAR (USING TECHSTREAM)
(a) Clear the DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the tester on.
(4) Clear the DTCs using the Techstream.
Select the following menu items: Chassis / ABS/VSC/TRAC / DTC / Clear.
3. DTC CHECK (USING SST CHECK WIRE)
(a) Check DTCs.




(1) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
(2) Turn the ignition switch to ON.
(3) Read 2-digit DTCs indicated by the blinking of the ABS warning light on the combination meter.
HINT:
- If the ABS warning light does not blink, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are described in the sections listed in the table below.





- As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.




- DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" ABS (Antilock Brake System) (for Sedan).
(4) After completing the check, disconnect SST from terminals TC and CG of the DLC3, and turn the ignition switch off.
HINT: If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.

4. DTC CLEAR (USING SST CHECK WIRE)
(a) Clear the DTCs.




(1) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
(2) Turn the ignition switch to ON.




(3) Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.
(4) Check that the warning light blinks in the normal system code pattern.
(5) Remove SST from the terminals of the DLC3.
(6) Turn the ignition switch off.
HINT: The DTCs cannot be cleared by removing the battery cable or ECU-IG fuse.

5. END OF DTC CHECK/CLEAR
(a) Turn the ignition switch to ON.
(b) Check that the ABS warning light goes off within approximately 3 seconds.
(c) Turn the ignition switch off.