Removal

BRAKE: BRAKE BOOSTER: REMOVAL

REMOVAL
NOTE: Release the vacuum from booster by depressing the brake pedal several times.

Then remove the brake master cylinder from brake booster.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.

3. REMOVE FRONT WIPER ARM HEAD CAP (for Hatchback) Removal
4. REMOVE FRONT WIPER ARM HEAD CAP (for Sedan) Removal
5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for Hatchback) Removal
6. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for Sedan) Removal
7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for Hatchback) Removal
8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for Sedan) Removal
9. REMOVE HOOD TO COWL TOP SEAL (for Hatchback) Removal
10. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY LH (for Sedan) Removal
11. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY RH (for Sedan) Removal
12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Hatchback) Removal
13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Sedan) Removal
14. REMOVE COWL TOP VENTILATOR LOUVER LH (for Hatchback) Removal
15. REMOVE FRONT WIPER MOTOR AND LINK (for Hatchback) Removal
16. REMOVE FRONT WIPER MOTOR AND LINK (for Sedan) Removal
17. REMOVE COWL TO REGISTER DUCT SUB-ASSEMBLY (for Hatchback) Removal
18. REMOVE FRONT AIR SHUTTER SEAL (for Sedan) Removal
19. REMOVE OUTER COWL TOP PANEL (for Hatchback) Removal
20. REMOVE OUTER COWL TOP PANEL (for Sedan) Removal
21. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for Hatchback) Removal
22. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for Sedan) Removal
23. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Hatchback) Removal
24. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Sedan) Removal
25. REMOVE BATTERY Removal
26. REMOVE BATTERY TRAY
27. REMOVE BATTERY CARRIER Removal
28. REMOVE BRAKE ACTUATOR (for Hatchback) Removal
29. REMOVE BRAKE ACTUATOR (for Sedan) Removal
30. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle) Removal
31. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS) Removal
32. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS) Removal
33. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS Removal
34. REMOVE FRONT BRAKE TUBE (w/o ABS)





(a) Using a union nut wrench, separate the 2 brake tubes from the brake tube No. 1 way.





(b) Using a union nut wrench, remove the brake tube assembly from the proportioning valve.
35. REMOVE BRAKE BOOSTER





(a) Slide the clip and disconnect the vacuum hose from the check valve.





(b) Remove the 4 nuts and remove the brake booster.
(c) Remove the gasket from the brake booster.
(d) Loosen the push rod lock nut and remove the push rod clevis.





36. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
(a) Remove the vacuum check valve from the brake booster.
(b) Remove the grommet from the brake booster.