Removal

1NZ-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. DRAIN ENGINE COOLANT Service and Repair
3. REMOVE CYLINDER HEAD COVER NO. 2 Removal
4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE NO. 1





(a) Disconnect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 from the vacuum switching valve assembly.
(b) Disconnect the vacuum switching valve assembly connector and wire harness clamp.





(c) Disconnect ventilation hose No. 2.





(d) Disconnect the wire harness clamp and mass air flow meter connector.





(e) Loosen the hose clamp, unlock the air cleaner assembly clamp and remove air cleaner cap sub-assembly with air cleaner hose No. 1.





5. DISCONNECT WATER BY-PASS HOSE
(a) Disconnect the water by-pass hose.





6. DISCONNECT WATER BY-PASS HOSE NO. 2
(a) Disconnect water by-pass hose No. 2.
7. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY





(a) Disconnect the throttle with motor body assembly connector.
(b) Remove the nut and remove the wire harness with bracket.





(c) Remove the 2 nuts and remove the water filler sub-assembly with hose.





(d) Remove the bolt and 3 nuts and remove the throttle with motor body assembly.





(e) Remove the gasket from the intake manifold.