Removal

U340E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT WHEELS
3. REMOVE ENGINE UNDER COVER LH
4. REMOVE ENGINE UNDER COVER RH
5. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain the automatic transaxle fluid.
(b) Install a new gasket and the drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
6. REMOVE FRONT AXLE HUB NUT LH Removal
7. REMOVE FRONT AXLE HUB NUT RH
HINT: The removal procedure for the RH side is the same as that for the LH side.

8. SEPARATE FRONT SPEED SENSOR LH (w/ ABS) Removal
9. SEPARATE FRONT SPEED SENSOR RH (w/ ABS)
HINT: The separation procedure for the RH side is the same as that for the LH side.

10. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH Removal
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.

12. SEPARATE TIE ROD END SUB-ASSEMBLY LH Removal
13. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.

14. SEPARATE FRONT LOWER SUSPENSION ARM LH Removal
15. SEPARATE FRONT LOWER SUSPENSION ARM RH
HINT: The separation procedure for the RH side is the same as that for the LH side.





16. REMOVE TRANSMISSION CASE PROTECTOR (w/o ABS)
(a) Remove the 2 bolts and remove the transmission case protector from the automatic transaxle.
17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal
18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal





19. REMOVE FRONT TRANSAXLE CASE OIL SEAL
(a) Using SST, remove the front transaxle case oil seal.
SST: 09308-00010





20. REMOVE TRANSAXLE CASE OIL SEAL
(a) Using SST, remove the transaxle case oil seal.
SST: 09308-00010