Diesel Data: Automotive Repair

Removal





2ZR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: REMOVAL

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT
Removal.

2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

HINT
Removal for C59.

3. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

HINT
Removal for U341E.

4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) Removal

5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle) Removal

6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-58014

91551-80840

SST : 09330-00021

NOTICE:
Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.

(b) Remove the 8 bolts and flywheel.





7. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-58014

91551-80840

SST : 09330-00021

NOTICE:
Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.

(b) Remove the 8 bolts, rear spacer, drive plate and front spacer.





8. REMOVE REAR ENGINE OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.





(b) Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

NOTICE:
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.