Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT SEAT CUSHION ASSEMBLY (w/ Occupant Classification ECU, Occupant Classification Sensor): REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE FRONT SEAT HEADREST ASSEMBLY RH (w/o Seatback Board)

4. REMOVE OUTER SEAT TRACK COVER RH (w/o Seatback Board)

HINT
Use the same procedure for the RH side and LH side Removal.

5. REMOVE INNER SEAT TRACK COVER RH (w/o Seatback Board)

HINT
Use the same procedure for the RH side and LH side Removal.

6. REMOVE FRONT SEAT ASSEMBLY RH (w/o Seatback Board)

HINT
Use the same procedure for the RH side and LH side Removal.

7. REMOVE FRONT SEAT HEADREST ASSEMBLY RH (w/ Seatback Board)

8. REMOVE OUTER SEAT TRACK COVER RH (w/ Seatback Board) Removal

9. REMOVE INNER SEAT TRACK COVER RH (w/ Seatback Board)

for 2WD: Removal

for 4WD: Removal

10. REMOVE FRONT SEAT ASSEMBLY RH (w/ Seatback Board) Removal

11. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

w/o Seatback board: Use the same procedure for the RH side and LH side Disassembly.

w/ Seatback board: Disassembly

12. REMOVE FRONT SEAT CUSHION SHIELD RH

w/o Seatback board: Use the same procedure for the RH side and LH side Disassembly.

w/ Seatback board: Disassembly

13. SEPARATE FRONT SEAT INNER BELT ASSEMBLY RH

(a) Remove the nut and separate the front seat inner belt assembly RH.





14. REMOVE FRONT SEAT CUSHION INNER SHIELD RH

w/o Seatback board: Use the same procedure for the RH side and LH side Disassembly.

w/ Seatback board: Disassembly

15. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH

w/o Seatback board: Use the same procedure for the RH side and LH side Disassembly.

w/ Seatback board: Disassembly

16. REMOVE OCCUPANT CLASSIFICATION SENSOR

(a) Disconnect the connector.





(b) Using a screwdriver with the tip wrapped with protective tape, disengage the claw and separate the connector.

NOTICE:
Do not kink the pressure hose.

(c) Using a clip remover, remove the 2 clips and occupant classification sensor.





NOTICE:
When the occupant classification sensor is replaced, be sure to replace the occupant classification ECU as a set.

17. REMOVE OCCUPANT CLASSIFICATION ECU

(a) Disconnect the connector from the occupant classification ECU.





(b) Remove the 2 bolts and occupant classification ECU.