Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION

1. INSTALL STEERING PAD

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the 2 airbag connectors to the steering pad.





NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.

(d) Push in the 2 locks to install the airbag connectors.

(e) Connect the horn connector to the steering pad.

(f) Push the steering pad to engage the 2 pins.





NOTICE:
Make sure that the pins are securely inserted into the steering wheel holes.

2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

(a) Install the lower No. 3 steering wheel cover with the 2 claws.

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

(a) Install the lower No. 2 steering wheel cover with the 2 claws.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. INSPECT STEERING PAD

(a) Make sure that the horn sounds.

HINT
If the horn does not sound, inspect the horn system Symptom Related Diagnostic Procedures.

6. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.