Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

2. POSITION FRONT WHEELS STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal

5. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

6. REMOVE STEERING PAD Removal

7. REMOVE STEERING WHEEL ASSEMBLY Removal

8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal

10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal

11. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal

12. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Removal

13. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Removal

14. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

15. REMOVE FRONT UPPER CONSOLE BOX Removal

16. REMOVE NO. 2 SWITCH HOLE BASE Removal

17. REMOVE CONSOLE BOX CARPET

18. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 2WD) Removal

19. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 4WD) Removal

20. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal

21. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal

22. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle) Removal

23. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Removal

24. REMOVE NO. 1 SWITCH HOLE BASE Removal

25. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

26. REMOVE LOWER STEERING COLUMN COVER Removal

27. REMOVE UPPER STEERING COLUMN COVER Removal

28. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Disconnect the connectors from the spiral cable with steering angle sensor.





NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.

(b) Disengage the 3 claws and remove the spiral cable with steering angle sensor.

29. REMOVE SPIRAL CABLE

(a) Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.