DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Monitor System - Diagnostics - Introduction >> Blind Spot Monitor System >> Customize Parameters [11/2023 - ] >> Customize Parameters [11/2023 - ]

Customize Parameters [11/2023 - ]

  1. CUSTOMIZE BLIND SPOT MONITOR SYSTEM 
    1. Customizing with the GTS
      NOTE:
      • When the customer requests a change in a function, first make sure that the function can be customized.
      • Be sure to make a note of the current settings before customizing.
      • When troubleshooting a function, first make sure that the function is set to the default setting.
      1. Connect the GTS to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the blind spot monitor system on.
      4. Turn the GTS on.
      5. Enter the following menus: Body Electrical / Blind Spot Monitor "B" or Blind Spot Monitor "A" / Utility
      6. Select the setting by referring to the table below.

        Blind Spot Monitor 

        Tester Display Description Default Setting ECU
        BSM Function Switches the BSM function on and off. Valid $00:Valid, $01:Invalid Blind Spot Monitor Sensor LH (B)
        RCTA Function Switches the RCTA function on and off. Valid $00:Valid, $01:Invalid Blind Spot Monitor Sensor LH (B)
Diesel-Data.com