DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Monitor System - Diagnostics - Introduction >> Blind Spot Monitor System >> DTC Check / Clear [12/2019 - 11/2023] >> DTC Check / Clear [12/2019 - 11/2023]

DTC Check / Clear [12/2019 - 11/2023]

  1. CHECK DTC 
    1. Connect the GTS to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the blind spot monitor system on.
    4. Turn the GTS on.
    5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

      HINT: 

      The blind spot monitor sensor RH (slave) and the blind spot monitor sensor LH (master) both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.

      Body Electrical > Blind Spot Monitor Master > Trouble Codes 

      Body Electrical > Blind Spot Monitor Slave > Trouble Codes 

    6. Check for DTCs.

      Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2019 - 11/2023] 

  2. CLEAR DTC 
    1. Connect the GTS to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the blind spot monitor system on.
    4. Turn the GTS on.
    5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

      Body Electrical > Blind Spot Monitor Master > Clear DTCs 

      Body Electrical > Blind Spot Monitor Slave > Clear DTCs 

    6. Clear the DTCs.
Diesel-Data.com