Installation [12/2019 - ]: Procedure

1. Engage the 2 guides and 2 claws as indicated by the arrows in the order shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Heater Area
   	Install in this Direction (1)
   	Install in this Direction (2)

   NOTE:

   • Make sure that the 2 claws are engaged as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.
   • Do not apply force to the heating element of the forward recognition with heater hood sub-assembly or an open circuit may result.
2. Engage the clamp and 4 ribs to install the forward recognition with heater hood sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Clamp
   *b	Rib

   NOTE:

   • As the No. 1 forward recognition cover cannot be installed correctly if the clamp and ribs are not engaged securely, make sure to engage each clamp and rib securely.
   • Do not forcibly pull the wire harness as it may become damaged.

   HINT: 

   Engage the clamp and ribs in the order shown in the illustration.

3. Connect the connector.

Refer to INSTALLATION [12/2019 - 09/2020] , or refer to INSTALLATION [09/2020 - 11/2023] , or refer to INSTALLATION [11/2023 - ]