DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 80 (Hybrid Transaxle System (P810) - Service Information) >> Motor Cable >> Removal [11/2023 - ] >> Procedure

Removal [11/2023 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INVERTER WITH CONVERTER ASSEMBLY 

    Refer to REMOVAL [11/2023 - ]

  2. REMOVE MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    1. Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.
      GTY944717Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.
      GTY922205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.
      GTY891120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Waterproof Seal
      NOTE:
      • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
      • Do not touch the waterproof seal or terminals of the motor cable.
      • Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.
Diesel-Data.com