Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Initialize position control ECU | Front Power Seat Control System (w/ Memory) | Refer to REGISTRATION [11/2023 - ] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link Stop and Start System Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted. Refer to PRECAUTION [11/2023 - ] Lane Control System Perform steering sensor zero point calibration Refer to INITIALIZATION [12/2019 - ] Pre-collision System Lighting System (EXT) (w/ AFS) - LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link Power Door Lock Control System Initialize back door lock Refer to INITIALIZATION [11/2023 - ] Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2023 - ] Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. -