Front Door Courtesy Switch Circuit [12/2019 - 11/2023]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   FR Door Courtesy SW	Front door courtesy light switch assembly (for RH) signal	OFF or ON	OFF: Front door RH closed ON: Front door RH open	-
   FL Door Courtesy SW	Front door courtesy light switch assembly (for LH) signal	OFF or ON	OFF: Front door LH closed ON: Front door LH open	-

   Body Electrical > Main Body > Data List 

   Tester Display
   FR Door Courtesy SW
   FL Door Courtesy SW

   OK

   Normal conditions listed above are displayed.

   Result

   Result	Proceed to
   OK	A
   NG ("FR Door Courtesy SW" is not normal)	B
   NG ("FL Door Courtesy SW" is not normal)	C

Result: 

A 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - 11/2023]  

Result: 

C 

See step  4

Result: 

B 

See step  2

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH). Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  3

1. Disconnect the H43 main body ECU (multiplex network body ECU) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M3-1 - H43-6 (FRCY)	Always	Below 1 Ω
   M3-1 or H43-6 (FRCY) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH). Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  5

1. Disconnect the H43 main body ECU (multiplex network body ECU) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M47-1 - H43-1 (FLCY)	Always	Below 1 Ω
   M47-1 or H43-1 (FLCY) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR